Ge Networx Nx 8e Programming Manual Read/Download This driver can create a virtual keypad for a GE Networx NX-8 security panel with the NXE Panel Programming Information on these features is below: NetworX™ NX-8V2 LED Keypad User Manual POWER Light is “on” when AC power is present, flashes to indicate a low battery condition. User Manuals, Guides and Specifications for your GE NetworX NX-6V2 Control Panel, Keypad. The NX-8E is probably the most flexible, durable, and. The NX-8E NetworX from Caddx represents a new approach to the design of security systems.The enrolling process takes about 12 seconds, during which time the Service LED illuminates. When you exit program mode, the NX-8V2 automatically enrolls the devices. Enter program mode and program the desired settings for each module. When c onnecting more than one keypad to the end of the wire, a higher gauge wire will be required.) WHEN CONNECTED TO NX-8V2 WHEN CONNECTED TO NXE Length in feet Wire Gauge Wire Gauge 24 22 20 18 18 16 16 14 14 1. I’ll have to look into that.NETWORX KEYPAD MAXIMUM WIRE RUN (Note: These numbers are for one keypad at the end of the wire. The basic premise is not much different than the wireless firefighter unit which monitors for the audio of interconnected devices, but may differ due to supervision capability in the firefighter or the fact it does not physically tie into the circuit.
I think due to UL, the manufacturer instructs users not to do it. I believe it is still within fire code to do so (use the relay) but you would need to check with your local authority. Under UL certification, monitored smokes have different requirements than non-monitored, so there are two separate certifications. Instead it is for non-monitored sirens, alerting devices, etc. The manufacturer recommendation is to not use the SM120X for a series of smokes and an Alarm control panel. If more than one smoke detector is in the circuit, using builder provided 120VAC smokes, there is no way of telling which tripped. See the attached capture from the manual. In the meantime, why? Why put in one orphan detector when there’s a whole interconnected loop which could just have a relay to connect to the control panel?įrom what I understand, this is likely due to UL and manufacturer.
0 kommentar(er)
